Anderson Powerpipe Installed

[Mustangcwo]

Started installing the Anderson Powerpipe yesterday and started the car up today.

First I had to expand the 3.5" hole in the engine bay fender wall to 4":

After I finished the expansion, I added the trim around the hole and then inserted the pipe:

Once the pipe is into the fenderwell, I hooked up the head unit (removed for install) and inserted the hard rubber elbow to the head unit.

Then I attached the MAF (had to pull the wiring harness to get enough wire...YIKES) and the air cleaner. Now I have to manufacture a plate to cover the hole and make a true cold air intake.

Here is the completed work!!!!!

 

[northerncountry]

Nice CWO that looks good Can't wait to see what your little red Fox can do on the track on Saturday

 

[orange395w]

Nice Todd! Did you drive it yet? I'm curious to know if you gained any boost?

 

[02gt]

before i put my pipe on i made 7 lbs and after i made close to 9 lbs, so that thing is deffinatly effective but it throws off the air/fuel alittle bit.

 

[Gibs]

Nice job Todd.

 

[Tommy]

Don't forget that wrench behind the dizzy!

 

[Renegade]

Don't forget that wrench behind the dizzy!

sharp eye

 

[sdsubzero4]

Looking good

 

[Mustangcwo]

Nice Todd! Did you drive it yet? I'm curious to know if you gained any boost?

I have not run the car yet, but I'll know tomorrow when I go to "Beef and Bun"

Tommy, that's a new power mod, dont give away all my secrets. That's an Mexican Dizzy Booster.