buildabury1987
Well-Known Member
Ive started but feel as if im doing something wrong, any help?
-
Hello there guest and welcome to our forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
anyone know anything about buffing and polishing?
- Thread starter buildabury1987
- Start date
Fighting Sailor
San Angelo TX
Dont put too much pressure on it and keep moving... You dont want to burn through your clear cote. Do it in sections too...
buildabury1987
Well-Known Member
im trying to put alittle life back into the paint but i think its too far gone. maybe a new paint job is in order.
SnakeBit
Well-Known Member
if you wanna do it right and get best results need to start with a rubbing compound then polish...then wax maybe even start with a clay bar
+1 for clay bar. about $20 from Wal Mart or any auto part store. Then you can use Nu Finish or any of the oxidation/swirl remover compounds. The paint was really bad on by last 'stang and I got got full kbb on trade-in after having a cheap detail done on it. You could shop around for a detail as well, cheaper than paint.
come by the house i will show u what i use to make mines shinny